cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
421
Views
5
Helpful
1
Replies

CVP using QSIG to a legacy PBX

michael_oldham
Level 1
Level 1

I wish to know if anyone has used CVP with a legacy switch where the connection between the PBX and CVP VXL router is QSIG and thus prevent call trombing or sometimes known as hairpinning after CVP transfers the callto an agent.

1 Reply 1

adignan
Level 8
Level 8

It will work no problem. As long as the voice gateway terminating the QSIG link is h.323.

From:

http://www.cisco.com/en/US/partner/products/sw/custcosw/ps1006/products_implementation_design_guide_chapter09186a008056bf5d.html

Signaling support includes T1/E1 Primary Rate Interface (PRI), T1 channel associated signaling (CAS), E1-R2, T1/E1 QSIG Protocol, T1 Feature Group D (FGD), Basic Rate Interface (BRI), foreign exchange office (FXO), E&M, and foreign exchange station (FXS). The Cisco 2600, 2800, 3700 and 3800 Series Routers can be configured to support from two to 540 voice channels.

please rate posts.

andy - berbee

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: