×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Configure EZVPN Network Extension mode that allows 7940 phone to connect te

Unanswered Question
Dec 27th, 2005
User Badges:

I would like to setup my 501 with ezvpn in network extension mode to:


1.Establish vpn tunnel to PIX HUB

2. Establish voip 7940 to call manager


This what I have applied on the pix 501


vpnclient server 6.x.x.x

2.vpnclient mode network-extension-mode


3 . vpnclient nem-st-autoconnect …. Specifies to automatically initiate IPSec

data tunnels when split tunneling is configured. Note that IPSec data tunnels

are automatically initiated and sustained when in network extension mode,

except when split tunneling is configured.


4. vpnclient username (your username) password (password)


5. vpnclient vpngroup HARDWARE password xxxxx


6. vpnclient enable


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
travis-dennis_2 Tue, 12/27/2005 - 13:58
User Badges:
  • Gold, 750 points or more

I am sure that someone is looking at your config and will post soon but for the rest of us why don't you tell us what the phone is doing and if the tunnel is even coming up or not?



Thanks,



Travis

tonyam98 Tue, 12/27/2005 - 15:56
User Badges:

Itis doing nothing at the moment ...previously when the hub pix 6.3 (4) the phone recieved a 10.60.60.x ip address ... below is this dhcp pool


dhcpd address 192.168.52.2-192.168.52.33 inside

dhcpd dns 206.13.28.12

dhcpd lease 3600

dhcpd ping_timeout 750

dhcpd auto_config outside

dhcpd option 150 ip 10.60.60.50

dhcpd enable inside

travis-dennis_2 Wed, 12/28/2005 - 17:27
User Badges:
  • Gold, 750 points or more

Is the tunnel up and staying up? If so what happens when you hard code the IP address, TFTP server etc into the phone? Does it work then?

Actions

This Discussion