×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.
rolandshum Tue, 12/27/2005 - 14:55
User Badges:

As long as the interfaces are on the same VLAN it shouldn't be an issue. I have that set up myself but the failover interface is cabled directly without a switch.

Corey OBrien Wed, 12/28/2005 - 06:18
User Badges:

Exactly how I planned to set it up. It seemed pointless to setup failover on the PIXs with the switch being a single point of failure. Thanks a lot.

Actions

This Discussion