This it is the unico that leaves when igniting router. it does not arrive at loads the ios. I have bought it but the salesman has disappeared. I have a previous exit of when attached this worked.

System Bootstrap, Version 11.3(2)XA4, RELEASE SOFTWARE (fc1)

Copyright (c) 1999 by cisco Systems, Inc.

TAC:Home:SW:IOS:Specials for info

C2600 platform with 40960 Kbytes of main memory

program load complete, entry point: 0x80008000, size: 0x7855e4

Self decompressing the image : #################################################

################################################################################

################################################################################

################################################################################

################################################################################

[OK]

Restricted Rights Legend

Use, duplication, or disclosure by the Government is

subject to restrictions as set forth in subparagraph

(c) of the Commercial Computer Software - Restricted

Rights clause at FAR sec. 52.227-19 and subparagraph

(c) (1) (ii) of the Rights in Technical Data and Computer

Software clause at DFARS sec. 252.227-7013.

cisco Systems, Inc.

170 West Tasman Drive

San Jose, California 95134-1706

Cisco Internetwork Operating System Software

IOS (tm) C2600 Software (C2600-IS-M), Version 12.0(7)XK1, EARLY DEPLOYMENT RELEA

SE SOFTWARE (fc1)

TAC:Home:SW:IOS:Specials for info

Copyright (c) 1986-2000 by cisco Systems, Inc.

Compiled Wed 15-Mar-00 04:42 by phanguye

Image text-base: 0x80008088, data-base: 0x80D4A898

cisco 2610 (MPC860) processor (revision 0x203) with 33792K/7168K bytes of memory

.

Processor board ID JAD04330L6A (2258657795)

M860 processor: part number 0, mask 49

Bridging software.

X.25 software, Version 3.0.0.

Basic Rate ISDN software, Version 1.1.

1 Ethernet/IEEE 802.3 interface(s)

1 ISDN Basic Rate interface(s)

1 ATM network interface(s)

32K bytes of non-volatile configuration memory.

16384K bytes of processor board System flash (Read/Write)

Hello,

this could be a problem with your physical memory. Can you open the box and reseat the memory modules (DRAM & Flash) ? Or better yet, if you have new memory available, replace the memory and load a new IOS ?

Saludos,

GP

I have replaced the Memory Flash and SDRAM another 2610 Memory of qu works perfectly. and It gives the same problem.

I have replaced power supli.

hi,

I have run your error through Cisco's Outut interpreter with the following results.

ERROR: The message 'Machine Check Exception' is displayed due to a hardware issue.

TRY THIS: If a new module has been recently installed, first try to remove it to

verify whether it is responsible for the error interrupt. If the error interrupt

persists, try to re-seat all removable components. If no changes like IOS upgrade

or hardware replacement are made and the error message appears continuously replace

the hardware.

HTH

Sarb