×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.
pkhatri Mon, 01/02/2006 - 05:58
User Badges:
  • Purple, 4500 points or more

Try the following:


interface

ip nat inside

!

interface

ip nat outside

!

ip nat outside source static


Also be sure that you have a route to the external(NATTED) address on your router or this will not work.


Regards,

Paresh

mheusinger Mon, 01/02/2006 - 05:58
User Badges:
  • Green, 3000 points or more

Hi,


you can use the "ip nat inside destination" command.

Have a look at

"Cisco IOS Network Address Translation Overview"

http://www.cisco.com/en/US/tech/tk648/tk361/technologies_white_paper09186a0080091cb9.shtml


or at

http://www.cisco.com/en/US/products/sw/iosswrel/ps5207/products_command_reference_chapter09186a0080238b73.html#wp1164300


Hope this helps


Martin

Actions

This Discussion