How do I test a new PRI to make sure I can actually place calls outbound?
We currently have 3 PRIs installed on our 3660 for inbound and outbound calls. Last night I plugged a new PRI to make 4 and configured the 3660 like so:
controller T1 3/0
pri-group timeslots 1-24 service mgcp
description Local T1
no ip address
no logging event link-status
isdn switch-type primary-4ess
isdn incoming-voice voice
isdn bind-l3 ccm-manager
no cdp enable
I went in to call manager and added the route group:
Then added the gateway.
I basically mimicked the configs that were already in place.
Now that everything is configured how to I test that specific PRI?