VPN and GLBP!!!

Unanswered Question
Jan 19th, 2006
User Badges:

Hi,

Does any body know when the "GLBP redundancy client" will be released?

Is it possible to configure VPN(site-to-site) and GLBP in same interface in Cisco router?

Is there any special commands or setup to look for?

Both GLBP and VPN is in WAN part.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 3 (1 ratings)
Loading.
b.hsu Wed, 01/25/2006 - 06:49
User Badges:
  • Silver, 250 points or more

(router-if)#glbp group name redundancy-name


Enables IP redundancy by assigning a name to the GLBP group.


The GLBP redundancy client must be configured with the same GLBP group name so the redundancy client and the GLBP group can be connected.


examples20001 Wed, 01/25/2006 - 07:34
User Badges:

I didnt get. Can you please give more details.

My router commands for GLBP is below:

TestC(config-if)#glbp ?

<0-1023> Group number

TestC(config-if)#glbp 10 ?

authentication Authentication method

forwarder Forwarder configuration

ip Enable group and set virtual IP address

load-balancing Load balancing method

name Redundancy name

preempt Overthrow lower priority designated routers

priority Priority level

timers Adjust GLBP timers

weighting Gateway weighting and tracking

TestC(config-if)#glbp 10 name ?

WORD Name string

TestC(config-if)#glbp 10 name load

TestC(config-if)#


>>>The GLBP redundancy client must be configured with the same GLBP group name so the redundancy client and the GLBP group can be connected.


How to configure the GLBP redundancy client?

Actions

This Discussion