×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.
Chris Deren Thu, 01/19/2006 - 04:45
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,
  • Cisco Designated VIP,

    2017 IP Telephony, Contact Center, Unified Communications

I don't think it is supported, take a look at the release notes of the latest devicepack for 3.3

http://ftp-sj.cisco.com/cisco/voice/callmgr/3.3/ciscocm.3-3-DevPack-65.6_readme.htm


7941 is listed for CCM 3.3.5, but not 7941G-GE.

However, they both use the same firmware and should work OK for the most part. Don't use it with TAPS as for TAPS the model has to be exactly the same (speaking from experience).


Chris

Actions

This Discussion