×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Policy-Based Routing to a subnet

Unanswered Question
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
pkhatri Thu, 01/26/2006 - 17:45
User Badges:
  • Purple, 4500 points or more

Hi,


If you mean that you want to configure PBR with a next-hop that is not directly attached, then the answer is yes. To do so, use the 'set ip next-hop recursive ' command. As long as the router can recursively work out where the specified next-hop address is, it will work fine.


Hope that helps - pls rate the post if it does.


Regards,

Paresh





Actions

This Discussion