problem with install "VIC2-4FXO"

Unanswered Question
Feb 4th, 2006
User Badges:

hello

could you pol help me about this problem:

I have one 2611xm that I fill the network module of this router with "NM-16AM-V2" so, I have not any more nm module. but I want use "VIC2-4FXO" for voice,can i use it in wic slot or I should use this card in NM-V@ modele?


thanks for your attention

ladan

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
pkhatri Sat, 02/04/2006 - 23:36
User Badges:
  • Purple, 4500 points or more

Hi Ladan,


Unfortunately, you cannot install the VIC2-4FXO in a WIC slot on a 2611XM. You need to use one of the following network modules for this:

NM-HDV2

NM-HD-2VE

NM-HD-1v

NM-HD-2V


Pls remember to rate posts that help.


Paresh

ladan.eftetahi Sun, 02/05/2006 - 01:00
User Badges:

thanks paresh for helping me

could you pls tell me what can I do if I want to have voice "vic" on 2611xm without using network module.

thanks


pkhatri Sun, 02/05/2006 - 03:20
User Badges:
  • Purple, 4500 points or more

Hi Ladan,


As I mentioned in my first post, you simply cannot use a VIC card in a 2611XM without using a network module.


One alternative is to get a VWIC card which you can install in a WIC slot provided you also get an AIM-VOICE module.


Hope that helps - pls rate the post if it does.

Paresh

thisisshanky Sun, 02/05/2006 - 06:59
User Badges:
  • Purple, 4500 points or more

You have a few alternatives...


a. See if you can get vic-2fxo (version 1) and use a module such as NM-1V or NM-2V on the 2611.


b. Use a module such as NM-HDV2, NM-HD-1V or NM-HD-2V and put the VIC2-2FXO in the built in slot of the network module. NM-HDV2 requires that you put PVDMs in the module. NM-HD-1V and NM-HD-2V has built in DSP chips.


c. Use AIM-VOICE-30 on the AIM slot of 2611, and use the VIC2-2FXO in the regular WIC slot of the router. AIM-VOICE-30 has built in DSP chips.


d. Use a 2800 series router and use the VIC2-2FXO in any of the HWIC slots. You will also need PVDM2 chips on the PVDM slots on the motherboard of the router.


HTH


PS: please remember to rate helpful replies!

ladan.eftetahi Mon, 02/06/2006 - 05:08
User Badges:

Hi shanky

thanks for your help

so, finally I know that I can buy "VIC2-4FXO"

with one "AIM-VOICE-30"on 2611xm without using any nm module ? is it ok?


thanks so much

Actions

This Discussion