How to configure router in bridge mode

Answered Question
Feb 8th, 2006


I have 2 cisco 2621 series routers to be configured in bridge mode.

i'll be connecting this 2 routers using serial connection 128 lease line.

the problem is im not sure how to configure this 2 routers in bridge mode.

as far as i know, i need to issue the command no ip routing.

is there anything else i need to do?

can anyone guide me on how to configure

the router in bridge mode? is there any support page for this is cisco website?



I have this problem too.
0 votes
Correct Answer by lgijssel about 10 years 7 months ago

Please check the link to the configuration guide below. It describes how to configure transparent bridging.



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4 (1 ratings)
CSCO10587322 Wed, 02/08/2006 - 17:48

Hi Friend

Thank you so much for your immediate reply.

I managed to find some clear guide on configuring routers in bridge mode. really appreciate your help

your solution did helped me.




This Discussion