cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
337
Views
0
Helpful
3
Replies

Problem with Console on 5500 Catalyst Switch

schadmin
Level 1
Level 1

We have a Catalyst 5500 switch that runs the CatOS (not native) and I was curious to know what the commands are to see what speed the Console Line is running at (since I am having trouble connecting to the switch with a console connection). I know in natvie you can just look under "line con 0", but how do you do that with the hybrid OS? Thanks in advance!

3 Replies 3

glen.grant
VIP Alumni
VIP Alumni

Are you using a straight thru cable to try and get into the console , these do not take the standard console cable that cisco supplies.

I am using the one-piece, light-blue rollover cable that cisco provides. Should I be using the old ones that are essentially 2 peices? The one's where the DB9 is a seperate peice from the cable?

That's a rolled cable for Cat5000 use straight through:

To connect a terminal to the Supervisor Engine II G, III, III G, III FSX or III FLX console port, plug an RJ-45-to-RJ-45 straight-through cable into the console port jack.

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat5000/hardware/quik_hw/5000quik.htm#14343

Before connecting the console port, check the terminal documentation to determine the baud rate. The baud rate of the terminal must match the default baud rate (9600 baud) of the console port. Set up the terminal as follows:

* 9600 baud

* 8 data bits

* No parity

* 1 stop bit

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat5000/hardware/supervis/03instal.htm#xtocid1620216

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco