×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

PVC

Unanswered Question
Feb 21st, 2006
User Badges:

I was working on a 2811router with a T1 connection, my configuration is right, so was the settings at the carrer site(AT&T), I wasn't seeing protocol.

Carrier was able to loop the CSU(in-built), but wasn't receiving any data back from the equipment, all settings and config. has been checked, no luck. Can someone help?

Thanks

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
mounir.mohamed Thu, 02/23/2006 - 01:49
User Badges:
  • Gold, 750 points or more

Dear bensonomuke,


Ask your carrier to give u loop on the circute and check if you can receive or not, failed to receive the loop meaning that there is a physical problem.



Best Regards,

Mounir Mohamed

Actions

This Discussion