×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Problem with client remote connection

Unanswered Question
Feb 27th, 2006
User Badges:

I have a VPN set up in office.

Clients are able to connect from remote site (behind another PIX), but unable to ping or connect to any devices.


It was noticed that in the client's statistics, the number of Encrypted Packets is increasing,but the Decrypted Packets remained at 0.


After i configure NAT from public to private IP address, the problem was resolved.

like to seek advise on what to do, to allow clients to connected to Office's devices without configuring NAT on other remotes' PIX?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
sr1568922 Tue, 02/28/2006 - 02:04
User Badges:

It is noted that the client is not receiving any VPN packets.

spremkumar Wed, 03/01/2006 - 01:09
User Badges:
  • Red, 2250 points or more

hi


I suspect in your pix the return traffic pointing towards your client vpn pool mite be getting natted.


access-list 101 permit ip 192.168.10.0 255.255.255.0 172.16.1.0 255.255.255.0

!

nat (inside) 0 access-list 101


in this where 172.16.1.0/24 is assumed as the vpn pool assigned to the remote users & 192.168.10.0/24 you local lan block.


regds


Actions

This Discussion