×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

VLAN interfaces on PIX 535 6.3(4)

Unanswered Question
Mar 3rd, 2006
User Badges:

I have a number of vlan interfaces up and running in a production environment on our PIX 535 failover firewall pair. I had set up an IP address and failover IP on the physical interface, which is totally unused. Since I mistakenly used

loopback range addresses for this, failover keeps complaining that the remote fw is unreachable on this interface, generating log entries. I'd like to just remove the IP address and failover IP for the physical interface and leave the vlan interfaces information as is. My questions are:


1>Is this configuration supported?

2>If so, will the removal cause any outages for the vlan interfaces?


thanks in advance,


Peter

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
phaddad Fri, 03/03/2006 - 10:25
User Badges:

moving this topic to Ask the expert,


thanks,


Peter

Actions

This Discussion