×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

auto-cut-through command on E&M module

Unanswered Question
Mar 6th, 2006
User Badges:

Hi everyone,


I have a question of auto-cut-through command on a cisco 3600 router.


I connected a cisco 3600 router to other band PBX with 2 E&M module on wink-start signaling and did auto-cut-through command each pots.


voice-port 1/0/0

auto-cut-through


Phone A(FXS) -- Router --- (E&M) --- PBX --- Phone B(FXS)


Phone-A calls Phone-B.


If PBX is not provide answer supervison or wink to the call, is call compeltion ?



Thanks.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
ssoberlik Fri, 03/10/2006 - 10:57
User Badges:
  • Bronze, 100 points or more

The command 'auto-cut-through' should allow the call to complete even if the PABX does not provide M lead response.



Actions

This Discussion