×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

What to command to use to show IP address

Unanswered Question
Mar 9th, 2006
User Badges:

Gurus, I have a Catalyst 3560, and was wondering what command I could use to show the IP Address of the device plugged into a specific port?


Thanks!

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (2 ratings)
Loading.
pkhatri Thu, 03/09/2006 - 15:56
User Badges:
  • Purple, 4500 points or more

Hi Mate,


Switches don't collect information on IP addresses plugged into a port. The only thing you can get is the MAC address of the device plugged into the port.


Hope that helps - pls rate the post if it does.


Paresh

glen.grant Thu, 03/09/2006 - 16:03
User Badges:
  • Purple, 4500 points or more

If you have a switch that is non trunked sometimes you can ping the broadcast address of the subnet and then look in the arp table after you know the mac from looking in the mac-address-table .

Actions

This Discussion