×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.
pkhatri Fri, 03/17/2006 - 16:31
User Badges:
  • Purple, 4500 points or more

You can terminate PPTP tunnels from hosts using PPTP with MPPEbut I'm don't believe you can configure a PPTP tunnel between two Cisco devices.


You might want to look at the following doc though:

http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121newft/121t/121t5/dt_pptp.htm


Hope that helps - pls rate the post if it does.

Paresh

Actions

This Discussion