Buy or Renew
Buy or Renew
Duo Security forums now LIVE! Get answers to all your Duo Security questions. Learn more
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
316
Views
0
Helpful
3
Replies

Mapping ports to MAC addresses on PIX

lalcantara
Level 1
Level 1

‎03-13-2006 03:16 PM - edited ‎02-21-2020 12:46 AM

Greetings,

I've been trying to look for anything relating to this over the Internet, but could not find anything.

Is it possible to map MAC addresses to certain ports/interfaces on a PIX, if so, can someone please point me to the right direction?

Thank you,

Lee

0 Helpful
3 Replies 3

aashish.c
Level 4
Level 4

‎03-13-2006 09:39 PM

Hi

AFAIK there is no method by which you can bind a mac address to ports/interfaces. Kindly update me about your specific requirement, so I could try to find a workaround.

regards

aashish C

0 Helpful

lalcantara
Level 1
Level 1
In response to aashish.c

‎03-13-2006 11:21 PM

Hi,

My other option was to lock down MAC addresses on the switch level. I was just curious if it was possible to do it on the PIX.

Thank you,

Lee

0 Helpful

aashish.c
Level 4
Level 4
In response to lalcantara

‎03-14-2006 01:16 AM

Ohh yes, switch would do this for you. PIX wont do it.

regards

aashish C

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card