×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.
adhernan Tue, 03/21/2006 - 09:41
User Badges:

You will want to look into the capabilities for configuring etherchannel on this router platform or pssibly bridge the two interfaces if channel is not an option. Yill also want to address this connnected switch.

christian.testa Thu, 03/23/2006 - 09:17
User Badges:

you can configure separate subnets on each link.

Fas0 x/30 subnet, Fas1Y/30 Subnet. Then include these networks under your routing process, eg EIGRP and will will have redundancy.

Actions

This Discussion