cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
547
Views
0
Helpful
2
Replies

Port redundancy on WLC 4400

prasannap
Level 1
Level 1

I am having problems with configuring the port redundancy on the WLC 4400.

Have configured 4 ap-manager interfaces all of them are in a single subnet.

They have been configured with a primary & backup ports but this configuration dose not work the way it should.

If port 1 fails all the AP on this port do not failover on to the backup port. If any of the other orts 2,3,4 fail then the the APs on the respective port join ports of randon choice not the one configured as backup ports

Has any one worked with this?

2 Replies 2

Not applicable

Check this link for configuring port redundancy in wirless lan controller.

http://www.cisco.com/en/US/products/ps6366/products_configuration_guide_chapter09186a008052d946.html#wp1145963

jdewberr
Level 1
Level 1

Hi Prasanna,

a prerequisite for the failover/redundancy working would be to upgrade to 3.2.116.21, see bug CSCsc98586

http://www.cisco.com/cgi-bin/Support/Bugtool/onebug.pl?bugid=CSCsc98586

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: