×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

How to replace failed supervisor module IV on Cisco WS-C4506

Unanswered Question
Mar 28th, 2006
User Badges:

Cisco IOS Software, Catalyst 4000 L3 Switch Software (cat4000-I5S-M), Version 12.2(25)EWA5. Cisco has RMA a new supervisor module. Please advise what are the steps to replace a failed sup mod

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Prashanth Krishnappa Tue, 03/28/2006 - 07:28
User Badges:
  • Cisco Employee,

If you have compact flash card, back up the configs and IOS to the flash card. Swap out the Supervisor, use the IOS and config on the compact flash card to boot the new Supervisor.


PS: Remember to rate useful posts.

shaunjabrook Tue, 03/28/2006 - 08:09
User Badges:

To be clear on my side - as i have never replaced a failed sup module before - i would take the following steps - i do have about 122 mb free on slot0:


copy bootflash: slot0:

cat4000-i5s-mz.122-25.EWA5.bin


copy bootflash: slot0:

running-config


Then - I should be able to hotswap the failed sup module with the new one.


copy slot0: bootflash:

cat4000-i5s-mz.122-25.EWA5.bin


copy slot0: bootflash:

running-config


Verify



Please advice - thanks

Actions

This Discussion