×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Cable to connect to LocalDirector console port

Unanswered Question
Mar 29th, 2006
User Badges:
  • Silver, 250 points or more

Hello,


my question is about getting access to the LocalDirector 430 through the console port: I thought it was just a regular rollover cable (with pins 1 through 8 reversed), but for some reason, that doesn´t seem to work. I know that there is a Cisco console kit for the LocalDirector, but does anybody know what the difference, if any, is between that console kit and a regular RJ-45 rollover cable ?

Thanks in advance for your help.


Regards,


Nethelper

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
beth-martin Tue, 04/04/2006 - 12:20
User Badges:
  • Bronze, 100 points or more

Console cable and the rollover cable are one and the same. Any device with a console port should work with the roll over cable.


Actions

This Discussion