Routing Issue between router and Access Server

m_aurangzeb · ‎03-31-2006

Hi,

We have a Lucent MAX TNT access server, having TAOS version 9.0.9. I

have configured

the default route so that all dialup user traffic is diverted towards

cisco 2611 series router but this

only happens with the IP subnets configured on MAX TNT and cisco router

ethernet interfaces.

We need a solution in which dailup users on MAX TNT with IPs from any network can

be routed towards the cisco router in order to reach the internet cloud accross the Router.

Richard Burts · ‎03-31-2006

Muhammad

Your message states that you have configured the access server with a default route pointing to the 2611 router. But it does not say whether you have configured a route on the 2611 pointing to the access server for the address range used by the dial pool which the access server uses to assign addresses to dial up users. I suspect this is your problem. I believe that the 2611 needs a route to that address space and that the 2611 needs to advertise that address range if there are any other routers in your network.

HTH

Rick

HTH

Rick