04-02-2006 08:08 AM - last edited on 03-25-2019 05:07 PM by ciscomoderator
dears,
can i Add secondary ip address to 506 firewall interface to support two different network
04-02-2006 09:03 AM
No this is not possible on the PIX Firewall.
You need an internal router to that or you can configure VLANs to a layer 3 capable Switch.
sincerely
Patrick
04-02-2006 09:13 AM
PIX 506 doesnt support secondary Ip, but you can use trunk with dot1q encapsulation
try following document Using VLANs with the Firewall:
http://www.cisco.com/en/US/products/sw/secursw/ps2120/products_configuration_guide_chapter09186a0080172786.html#wp1113411
M.
Hope that helps, rate if it does
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:
