×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

How to capture switch config from Hyperterminal

Unanswered Question
Apr 4th, 2006
User Badges:

Hi!!! I tried to capture configuration reports of a switch which i did from Hyperterminal.I went to the menu bar which in the top and went to transfer ,on the dropdown it says capture text.I did that but when i opened the captured file i can see the text scattered here and there.Is is possible to see the captured configurations of the switch as how we see organised in the hyperterminal.Can u pls tell me ,do i need to do any configurations in the hyperterminal before i could start capture text.

thanks and regards

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
spremkumar Tue, 04/04/2006 - 06:29
User Badges:
  • Red, 2250 points or more

hi


try opening the file either with wordpad or notepad.

sometimes it works fine with wordpad not though with notepad..



regds

Nicholas Vigil Tue, 04/04/2006 - 06:30
User Badges:

If you open the file using notepad it tends to scatter the text. Have you tried veiwing the file using wordpad instead?

jlwomeld Wed, 04/05/2006 - 11:14
User Badges:

on the hyperTerm

go to tranf

capture and give your file a location ex:c:\temp\test.txt and then hit the start button.

do a sh run on device.

Actions

This Discussion