config E1 on serial port ?

ducvu2005 · ‎04-04-2006

Dear all,

I have a Cisco 3660 router with Serial4T card and need to config E1 on these ports. Please help with the config. Thank you very much.

Duc Vu

P.S. Here is router's info:

interface Serial3/0

no ip address

shutdown

Serial3/0 is administratively down, line protocol is down

Hardware is QUICC Serial

MTU 1500 bytes, BW 2048 Kbit, DLY 20000 usec,

reliability 255/255, txload 1/255, rxload 1/255

Encapsulation HDLC, loopback not set

Keepalive set (10 sec)

Mueslix-4T Port adapter, 4 ports

Port adapter is disabled deactivated

Port adapter insertion time unknown

EEPROM contents at hardware discovery:

Hardware revision 1.1 Board revision D0

Serial number 14440376 Part number 800-02314-02

FRU Part Number: NM-4T=

Test history 0x0 RMA number 00-00-00

EEPROM format version 1

EEPROM contents (hex):

0x20: 01 54 01 01 00 DC 57 B8 50 09 0A 02 00 00 00 00

0x30: 68 00 00 00 99 05 17 00 00 05 FF FF FF FF FF FF

spremkumar · ‎04-05-2006

hi

Can you paste the show version output taken from your router so that the compatibility of the card to ur chasis can be found ?

i feel this message indicates that the particular card is not supported by the chassis in which you are installing the same.

"Port adapter is disabled deactivated"

output of show diag will also help to understand the exact problem ..also mention the type of the card which you are trying to install over there in ur router ...

regds