×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

How to enable dot1x multiple-authentication

Answered Question
Apr 5th, 2006
User Badges:

Help


How can I enable dot1x multiple-authentication on 2948G. The image is 8.2(GLX).


Thanks in Advance

Matt

Correct Answer by sundar.palaniappan about 11 years 4 months ago

I am quoting it (see below) from the link I sent to you in the previous post. Based on that it looks like it's supported on the 2948G switch


The Cisco Catalyst® Operating System (Catalyst OS) Software Version 7.5(1) for the supervisor engine supports the Cisco Catalyst 6500 Series and Cisco Catalyst 4000/4500 Series multilayer switches (including the Cisco Catalyst 2948G, 4912G, and 2980G-A switches).


Pls. rate all helpful posts.


HTH,

Sundar

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4 (2 ratings)
Loading.
sundar.palaniappan Wed, 04/05/2006 - 19:53
User Badges:
  • Green, 3000 points or more

Matt,


AFAIK, dot1x multiple host authentication isn't supported on 2948G switch.


HTH,

Sundar

mattkaya56 Thu, 04/06/2006 - 09:43
User Badges:

Thanks for the response.


Any other product other than Cat6500 that supports this?


Thanks

Matt

sundar.palaniappan Thu, 04/06/2006 - 09:53
User Badges:
  • Green, 3000 points or more

Matt,


3550/4500 switches support multi-host feature. There may be more products out there.


Pls. rate helpful posts.


--Sundar

mattkaya56 Thu, 04/06/2006 - 14:33
User Badges:

Hello Sundar,


Thanks for the response.


Multi-host does not give me what I want. I am looking for set port dot1x mod/port multiple-authentication which will force every mac on the port to undergo dot1x authentication. In the case of Multi-host only one of mac's need to authenticate - all the rest ride in for free.


I did locate a version 8.1 that supported this feature - can you please confirm if this is true.


Thanks

Matt

mattkaya56 Thu, 04/06/2006 - 15:38
User Badges:

Thanks again Sundar


Will it work on 2948G - according to 8.1 Command ref manual it does. Could you please confirm.


Thanks

Matt

Correct Answer
sundar.palaniappan Thu, 04/06/2006 - 15:45
User Badges:
  • Green, 3000 points or more

I am quoting it (see below) from the link I sent to you in the previous post. Based on that it looks like it's supported on the 2948G switch


The Cisco Catalyst® Operating System (Catalyst OS) Software Version 7.5(1) for the supervisor engine supports the Cisco Catalyst 6500 Series and Cisco Catalyst 4000/4500 Series multilayer switches (including the Cisco Catalyst 2948G, 4912G, and 2980G-A switches).


Pls. rate all helpful posts.


HTH,

Sundar

Actions

This Discussion