×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Modifying http fixup ports

Unanswered Question
Apr 10th, 2006
User Badges:

I have a requirement to allow http on non-standard ports, 1024-65535, on PIX535s.


I expected it to work by adding the ports as per configuration guide to fixup http, however it hasn't.


Do I need to allow the ports through the ACL's explicitly too, ie. allow tcp for ports 1024-64535? Obviously I would like to avoid doing this if possible.


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
joneschw1 Mon, 04/10/2006 - 12:02
User Badges:

Did you do a clear xlate? Also, I believe that if you need traffic to pass on one of those ports, you will have to open it up in the acl.

Actions

This Discussion