×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

how to use default route achieving load-balancing?

Answered Question
Apr 12th, 2006
User Badges:

show me an example

thanks

Correct Answer by pkhatri about 11 years 4 months ago

Try this:


ip cef

ip route 0.0.0.0 0.0.0.0 Serial0

ip route 0.0.0.0 0.0.0.0 Serial1


With the above config, the router will perform per-destination load-balancing. So for example, a session to IP 10.1.1.1 may go over Serial0 while the session to IP 192.168.1.1 may go over Serial1.


Pls do remember to rate posts.


Paresh

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
ankurbhasin Wed, 04/12/2006 - 21:17
User Badges:
  • Red, 2250 points or more

Hi Friend,


If you have 2 default route with same admin distance you can have equa load balancing.


Something like this


ip route 0.0.0.0 0.0.0.0

ip route 0.0.0.0 0.0.0.0


Now because these 2 default routes have equal admin distance so both will be peferred and will result into equal load ballancing.


HTH, if yes please rate the post.


Ankur

Correct Answer
pkhatri Wed, 04/12/2006 - 21:18
User Badges:
  • Purple, 4500 points or more

Try this:


ip cef

ip route 0.0.0.0 0.0.0.0 Serial0

ip route 0.0.0.0 0.0.0.0 Serial1


With the above config, the router will perform per-destination load-balancing. So for example, a session to IP 10.1.1.1 may go over Serial0 while the session to IP 192.168.1.1 may go over Serial1.


Pls do remember to rate posts.


Paresh

Actions

This Discussion