×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

snmp catalyst 3750

Unanswered Question
Apr 18th, 2006
User Badges:

I have turned on snmp for a catalyst 3750 but my fluke does not seem to be able to find any of my cisco switches. All I did was turn it on and create a read only community. Is there something else I need to configure?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Bobby Thekkekandam Tue, 04/18/2006 - 08:16
User Badges:
  • Cisco Employee,

Hi,


Do you know what OIDs the Fluke is polling? Some mibs require the so called Community String Indexing:


http://www.cisco.com/en/US/tech/tk648/tk362/technologies_tech_note09186a00801576ff.shtml


Basically, the read community string (say "public") you configured on the device gives you the

default VLAN 1 info. If you need something (such as BRIDGE-MIB) from VLAN10, you need to change the

community to "[email protected]" on your Fluke box to poll the Cat3750.


HTH,


Bobby


*Please rate helpful posts.

Actions

This Discussion