Rob Huffman Wed, 04/26/2006 - 04:41
User Badges:
  • Super Red, 40000 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 IP Telephony, Unified Communications

Hi Nicola,


The ATA does support "Call Display" analog phones.Have a look at the following;


Cisco ATA 186 and Cisco ATA 188 Features

----------------------------------------

The following list describes the Cisco ATA:


•Contains a single 10 BaseT RJ-45 port and two RJ-11 FXS standard analog telephone ports


•Supports G.711 alaw, G.711 mulaw, and G.723 and G.729a voice codecs


•Uses the Skinny Client Control Protocol


•Converts voice into IP data packets that are sent over a network


•Supports redial, speed dial, call forwarding, call waiting, call hold, transfer, conference, voice messaging, message-waiting indication, off-hook ringing, caller-ID, callee-ID, and call waiting caller-ID


From this doc for ccm 4.1.3


http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_administration_guide_chapter09186a00803edb01.html#wp1032269


Hope this helps!

Rob


Please remember to rate helpful posts.......

Actions

This Discussion