×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Cisco Security device manager (SDM) authentication fails

Unanswered Question
May 3rd, 2006
User Badges:

when i tried to install SDM on cisco2611 router it is asking for username & password of level 15 so configured a local user of level 15 on the router & provided the same creditentials to SDM installer but the authentications fails can any body pls clarify wht to do in this situation


regards & thanks in advance


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Richard Burts Sat, 05/06/2006 - 12:13
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN

I believe that SDM typically sets privilege level 15 on the vty. You might try that and see if it helps.


HTH


Rick

haris.cisco Mon, 05/08/2006 - 21:05
User Badges:

hi jeff,


there is no firewall in between or running on PC


and i tried your recomendationd but it did not work out.

is it any thing with the version of IOS, BTW i am using c2600-is-mz.12.2-34


regrds & Thanks in adv


Actions

This Discussion