×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

switch's LED don't change to green

Unanswered Question
May 4th, 2006
User Badges:

Hello,


The Cisco Catalyst switch 2955 is connected to another switch (extreme) with VLANs configured, the Cisco switch ports never change to green, and stays amber…


What are the possible problems…


Thanks in advanced,

Hugo


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
eward15 Thu, 05/04/2006 - 10:52
User Badges:

Look at the port status for those ports (show interface or show int status) as well as the spanning-tree status (show spanning-tree). Check for any blocked or err-disabled ports. Also check the logs to see what they say.

lgijssel Thu, 05/04/2006 - 10:58
User Badges:
  • Red, 2250 points or more

There are several possible causes:

1:Trunking mismatch > hard-code either access- or trunk mode (nonegotiate)

2:Port is spantree blocking > remove loops from the network.

3:Speed/duplex mismatch. > use fixed settings on both ends.


Regards,

Leo

Actions

This Discussion