×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Disabling split horizon for H-VPLS on 7609

Unanswered Question

Hi,


We installed a new 7609 in our lab for doing H-VPLS interop. The sw Version is IOS (tm) s72033_rp Software (s72033_rp-PSV-M), Version 12.2(18)SXD7.


I do not see the "no-split-horizon" option when trying to configure the remote spoke PE.


l2 vfi PE3-VPLS-A manual

vpn id 200

neighbor 20.0.0.1 encapsulation mpls <no-split-horizon>



Is there a version problem or some config issue ?


Thanks

AT

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.

The hw info is as follows :-


Mod Ports Card Type Model Serial No.

--- ----- -------------------------------------- ------------------ -----------

1 2 2+4 port GE-WAN OSM-2+4GE-WAN+ JAB0847061N

5 2 Supervisor Engine 720 (Active) WS-SUP720-BASE SAL0919113H


Mod Sub-Module Model Serial Hw Status

--- --------------------------- ------------------ ------------ ------- -------

5 Policy Feature Card 3 WS-F6K-PFC3BXL SAL09253GNF 1.6 Ok

5 MSFC3 Daughterboard WS-SUP720 SAL09190TCD 2.5 Ok

Harold Ritter Thu, 05/04/2006 - 18:30
User Badges:
  • Cisco Employee,

This option was introduced in 12.2(18)SXE and is therefore not present in the version you are currently running.


Hope this helps,

Actions

This Discussion