×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

VLAN Span on 6513

Unanswered Question
May 16th, 2006
User Badges:

I am troubleshooting a vlan spanning issue on a 6513 switch and am looking for any suggestions. Here are the particulers:


Version 12.2(18)SXD3


monitor session 1 source vlan 69

monitor session 1 destination int g6/35


The traffic happens to be routed between vlan 60 and vlan 69, both on the switch. When I capture the traffic, it looks as though I am only receiving half of the conversation(from vlan 69-->vlan60). I don't see the other half of the conversation.


The strange part is, I have a half dozen ports on a connected 3750 switch in vlan 69 that I see all of their traffic. So I am looking to the 6513 for issues/problems.


Anybody have some suggestions?


Thanks

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
glen.grant Tue, 05/16/2006 - 16:07
User Badges:
  • Purple, 4500 points or more

Haven't spanned much on the 720's is there a "monitor session 1 source vlan 69 both" command ? Usually you have to specify in, out or both as traffic directions..

tadamson Wed, 05/17/2006 - 07:01
User Badges:

By default, both directions are selected. When I do a show monitor, I get:


Type Local Session

Source VLANS

Both 69

Destin. Port Gi6/35


So, to me, that says that we should be getting both directions.



Actions

This Discussion