×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

counters not cleared in the clear counter command

Unanswered Question
May 23rd, 2006
User Badges:

May I know is there any counters in the "sh interface" that will not be cleared by the clear counter command ? I think "total output drop" is one. Can anyone verify ? good if anyone can share any cisco doc that show this.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 3.5 (2 ratings)
Loading.
a.hajhamad Fri, 05/26/2006 - 02:12
User Badges:
  • Bronze, 100 points or more

The clear counters command clear ALL the interface counters.

Please see the attached file which lists the show interface command and after the clear command issued, you can see the output show interface command, all the interface counters are cleared.


IOS clear counters command...

http://www.cisco.com/univercd/cc/td/doc/product/software/ios124/124tcr/tir_r/int_a1ht.htm#wp1199810


Please rate if it does!


Abd Alqader



Actions

This Discussion