×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Blocking inbound call in CM with MGCP Voice gateways

Unanswered Question
May 31st, 2006
User Badges:

I'm sure someone has posted on this: We have MGCP voicegateways and CM 4.02aSR2b. How can I setup CM to block a specific inbound call? If the gateways were H323 then no problem, but with MGCP we are stumped. Any suggestions? Thx!

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 3 (1 ratings)
Loading.
Chris Deren Wed, 05/31/2006 - 11:21
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,
  • Cisco Designated VIP,

    2017 IP Telephony, Contact Center, Unified Communications

It cannot be done with MGCP. It can be done with H.323 using reject translation rules on the GW.

With MGCP your only option is to route all calls via Unity or IPCC first where logic can be build to block calls.


HTH, please rate posts!


Chris

Actions

This Discussion