×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Connecting to a DEC600e

Unanswered Question
Jun 1st, 2006
User Badges:

Has anyone had the wonderful experience of connecting a Cisco router (a 2821 in this case) to a DEC600e carrier switch? I currently have 3 T1's (b8zs/esf wink) connected to an Avaya Definity G3si PBX. If I pull the T1's out of the Avaya and put them into my router, I can recieve calls, but not send them.


Does anyone have experience with this old DEC switch that can help?


Thanx,

-Tim

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
yshraybman Wed, 06/07/2006 - 16:55
User Badges:
  • Bronze, 100 points or more

you might want to check dial-peers config on 2821.

also might want to look into debugs. useful commands 'debug voip ccapi inout' and 'debug vpm signal'

Actions

This Discussion