×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

FXO issues

Unanswered Question
Jun 5th, 2006
User Badges:

I current have a 2811 ISR installed in New Zealand with a dual ISDN wic and a vic2-2fxo wic. In Australia I have a 2821 with a NM-HDA 12 port FXS module.


If i dial the bri port on the 2811 the phone rings on the 2821 and the call completes correctly. If I dial the fxo port on the 2811 i get static on the phone and the call eventully timeouts.


I've adjusted cptone and impedence with no help.


Paul


voice-port 0/1/0

compand-type a-law

cptone NZ

connection plar 300

description isdn port 0

!

voice-port 0/1/1

compand-type a-law

cptone NZ

connection plar 300

description isdn port 1

!

voice-port 0/2/0

cptone NZ

impedance complex3

description fxo port 1

!

voice-port 0/2/1

cptone NZ

connection plar opx 333

impedance complex3

description fxo port 2

!

!

!

!

!

dial-peer voice 1000 pots

voice cut-through alert

description Incoming ISDN Dialpeer

incoming called-number .

direct-inward-dial

port 0/1/0

!

dial-peer voice 1001 pots

voice cut-through alert

description Incoming ISDN Dialpeer

incoming called-number .

direct-inward-dial

port 0/1/1

!

dial-peer voice 1002 pots

description Incoming Analog Dialpeer

incoming called-number .

direct-inward-dial

port 0/2/0

!

dial-peer voice 1003 pots

description Incoming Analog Dialpeer

destination-pattern 0T

incoming called-number .

direct-inward-dial

port 0/2/1

!

dial-peer voice 3 voip

translation-profile outgoing calling

destination-pattern 333

session target ipv4:xxx.xxx.xxx.xxx

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
pacameron Sun, 06/11/2006 - 18:12
User Badges:
  • Silver, 250 points or more

Take the command 'direct-inward-dial' of dial-peer 1002 and 1003 - this is only used for PRI or BRI port types and is not needed on analogue port.


If this still does not help, post the SH VER and SH RUN from both routers so I can see if there is anything else in the configs that could be causing this.




pkrekelberg Wed, 06/14/2006 - 17:07
User Badges:

Thanks for your advise, and the issue has been fixed. It ended up being a crossed patch cable between the wall jack and the fxo port.

Actions

This Discussion