×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

assign a default route on MGX 8850 PXM1E

Unanswered Question
Jun 7th, 2006
User Badges:

Hi!

im unable to telnet to my remote mgx disk ip address. from the LAN side i can telnet to it but remotely i can't. I noticed on my other MGX, there is an entry on ROUTE NET TABLE (using routeshow cmd)


destination gateway ... interface

0.0.0.0 192.168.x.x lnPci0


would anybody know how this was done?


Many thanks!!

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
burugudunski Wed, 06/07/2006 - 21:53
User Badges:

Thanks!

i've read this article before but the default route refers to the Router Module. the 0.0.0.0 route refered i was referring to was for the PXM only. Thanks still for yoru reply!

Actions

This Discussion