06-07-2006 05:00 AM - edited 03-03-2019 12:55 PM
Hi!
im unable to telnet to my remote mgx disk ip address. from the LAN side i can telnet to it but remotely i can't. I noticed on my other MGX, there is an entry on ROUTE NET TABLE (using routeshow cmd)
destination gateway ... interface
0.0.0.0 192.168.x.x lnPci0
would anybody know how this was done?
Many thanks!!
06-07-2006 05:39 AM
hi
i read one documet. in this they have configure using
ip route 0.0.0.0 0.0.0.0 W.X.Y.Z 1
you can have this link
hope this willhelp you
regards
Devang
06-07-2006 09:53 PM
Thanks!
i've read this article before but the default route refers to the Router Module. the 0.0.0.0 route refered i was referring to was for the PXM only. Thanks still for yoru reply!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide