×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

lms 2.5.1/ cm 4.0.4/ dfm 2.0.4

Unanswered Question
Jun 14th, 2006
User Badges:

hi everybody


i have the following question regarding path analysis in campus mgr:


for some reason I don't see the layer-2-path and its devices, such as access-switches


device fault manager:


i have defined email-notification and out of this notification via sms-gateway which works perfectly but we get to many mails and sms-messages (e.g.messages from the device itself, messages from the interface and so on) in case of dfm-alerts. is there a possibility to set any parameters which helps to decrease the number of notification-messages ?


any hints or tips for regarding these 2 questions are very welcome and appreciated


thanks in advance


roman

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4 (1 ratings)
Loading.

Roman,


Path analysis: this might be because you have disabled IP redirects.

We have the same problem. CM states that the VLAN mapping table is not complete. But there are REALLY LIMITED number of mappings in this table. I found that IP redirects should be allowed in order to have path analysis to work.


Bas Kokken

David Stanford Wed, 06/14/2006 - 11:42
User Badges:
  • Cisco Employee,

For DFM:


You might want to modify your Notification Groups and modify if you are sending Critical, Warning and Informational Alerts or Events.


You can also look at your event sets to see if all events are needed to be sent.

Actions

This Discussion