Gig E port in err-disable

Unanswered Question
Jun 19th, 2006
User Badges:

I have a 6506 access switch with a gig port in err-disable. I shut/no shut the interface and it goes directly back into err-disable. I disconnected the cable from that port but still get the same problem. Any ideas before I open a TAC case?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
thomuff Mon, 06/19/2006 - 11:40
User Badges:

I had the same problem with an Uplink port. I had to add a command to the interface. I can't remember the command. I do know it was happening after a power generator test for the hospital.

Best thing is problably call the TAC.

vladrac-ccna Mon, 06/19/2006 - 11:41
User Badges:
  • Silver, 250 points or more


what is the cause of the errdisable state?

udld? link-flap ?

Please give us more information on this issue.


glen.grant Tue, 06/20/2006 - 04:21
User Badges:
  • Purple, 4500 points or more

Somewhere in your logs it should tell you why it errdisabled the port , need to look at that to get an idea.

b.orth Wed, 06/21/2006 - 04:06
User Badges:

Here is the error message I get:

%PM-SP-4-ERR_DISABLE: diagnostics error detected on Gi2/41, putting Gi2/41 in err-disable state

Also I have inline power set to never, because we have no devices using inline power right now.




This Discussion