06-19-2006 11:35 AM - edited 03-03-2019 03:43 AM
I have a 6506 access switch with a gig port in err-disable. I shut/no shut the interface and it goes directly back into err-disable. I disconnected the cable from that port but still get the same problem. Any ideas before I open a TAC case?
06-19-2006 11:40 AM
I had the same problem with an Uplink port. I had to add a command to the interface. I can't remember the command. I do know it was happening after a power generator test for the hospital.
Best thing is problably call the TAC.
06-19-2006 11:41 AM
Hello,
what is the cause of the errdisable state?
udld? link-flap ?
Please give us more information on this issue.
Vlad
06-20-2006 04:21 AM
Somewhere in your logs it should tell you why it errdisabled the port , need to look at that to get an idea.
06-21-2006 04:06 AM
Here is the error message I get:
%PM-SP-4-ERR_DISABLE: diagnostics error detected on Gi2/41, putting Gi2/41 in err-disable state
Also I have inline power set to never, because we have no devices using inline power right now.
Thanks,
Bob
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: