×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

ip nat ?

Unanswered Question
Jun 23rd, 2006
User Badges:

how do you nat a 11.0.0.0/8 network to a 10.0.0.0/8 network in a cisco 877 router. ie 10.1.143.251 to 11.1.143.251 and so on. i am trying to nat a specific address in a 10. network over to the relative 11. network.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
devang_etcom Fri, 06/23/2006 - 09:38
User Badges:
  • Gold, 750 points or more


it will be like this


ip nat inside source static 10.1.143.251 11.1.143.251


this is for enabling mapping of internal source address to global address


and

ip nat outside source static 11.1.143.251 10.1.143.251


this is for enabling mapping of global address to internal source address


hope this will help you


rate this post if it helps


regards

Devang

devang_etcom Fri, 06/23/2006 - 09:45
User Badges:
  • Gold, 750 points or more

and yes remember to add ip natinside or ip nat outside on interface...


and this are some good link which will help you:


Basic NAT:

http://www.cisco.com/en/US/tech/tk648/tk361/technologies_tech_note09186a0080094831.shtml


Configuration:

http://www.cisco.com/en/US/tech/tk648/tk361/technologies_tech_note09186a0080094e77.shtml


rate this post if it helps


regards

Devang


Actions

This Discussion