×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Catalyst 4500, supervisor II+, EIGRP

Unanswered Question
Jul 7th, 2006
User Badges:

Hi,


We're bought a catalyst 4500 sup II+ with image cat4000-i9s-mz.122-25.EWA4.bin


In feature navigator isn't anything about EIGRP in this image, but in CLI I may configure EIGRP.


How is that possible?


thx

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 1.5 (2 ratings)
Loading.
marekduba Fri, 07/07/2006 - 01:33
User Badges:

Yeah, i saw this about EIGRP stub... but if I write sh run command, there's no line with eigrp stub in router eigrp section.


Is the eigrp stub command on by default? And how can I check the stub settings?

marekduba Sun, 07/09/2006 - 03:49
User Badges:

So, there is routing proto's that I can configure in CLI... How is that possible?


bgp Border Gateway Protocol (BGP)

egp Exterior Gateway Protocol (EGP)

eigrp Enhanced Interior Gateway Routing Protocol (EIGRP)

isis ISO IS-IS

iso-igrp IGRP for OSI networks

mobile Mobile routes

odr On Demand stub Routes

ospf Open Shortest Path First (OSPF)

rip Routing Information Protocol (RIP)


slaurin Tue, 07/11/2006 - 05:49
User Badges:

Good morning,


Your image is IP BASE and it does not support EIGRP to be processed in hardware. It is going to work, but the switch will kick EIGRP out of the CPU.


You would need to download an ENHANCED L3 image to have native EIGRP support. Look for "is5s-mz" in the image, for example


cat4000-i5s-mz.122-25.EWA6.bin>>>>ENHANCED L3 (OSPF,EIGRP,IS-IS)


Regards,


Simon Laurin

glen.grant Mon, 07/17/2006 - 12:52
User Badges:
  • Purple, 4500 points or more

You will also see that the commands to run ospf and even bgp are in there and will work in a lab situation but also are not supported .

Actions

This Discussion