07-10-2006 11:39 PM - edited 03-09-2019 03:32 PM
how to set the management ip for a firewall say like we have a loopback int for router,switch..
07-11-2006 06:24 AM
Hello aksher@cisco,
You can't configure a loopback on a Pix. Why doesn't one of the interface addresses work for you? What are you trying to accomplish?
Hope this helps! If so, please rate.
Thanks
07-11-2006 06:38 AM
Aksher
If you are talking about accessing PDM (PIX Device Manger for management) via VPN from a remote site then yes this can be accomplished.
If want to run the PDM from your internal LAN, then again this can also be accomplished.
If you want to connect to the PIX via SSH then this also can be accomplished.
But NO you can not setup loopback addresses on the PIX.
So, which of the above method are you asking for?
Jay
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide