×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Cat4503 Supervisor software version

Unanswered Question
Jul 11th, 2006
User Badges:

How do I determine the software version of a Supervisor engine on a catalyst 4503?

Doing a Sho Ver I can easily identify the CatOS version, but not the sup eng version.

Thanks,

Andy

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Roberto Salazar Tue, 07/11/2006 - 15:13
User Badges:
  • Gold, 750 points or more

Sounds like you have a supII+ or above which runs IOS, therefore show verison will not show the sup type. Show module will show you the module model number:


4k#sh

Cisco Internetwork Operating System Software

IOS (tm) Catalyst 4000 L3 Switch Software (cat4000-IS-M), Version 12.1(13)EW, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)

TAC Support: http://www.cisco.com/tac

Copyright (c) 1986-2002 by cisco Systems, Inc.

Compiled Fri 20-Dec-02 13:52 by eaarmas

Image text-base: 0x00000000, data-base: 0x00E638AC


ROM: 12.1(12r)EW

Dagobah Revision 71, Swamp Revision 24


4k uptime is 13 weeks, 6 days, 20 hours, 37 minutes

System returned to ROM by power-on

System image file is "bootflash:cat4000-is-mz.121-13.EW.bin"


cisco WS-C4507R (XPC8245) processor (revision 5) with 524288K bytes of memory.

Processor board ID FOX06421AG6

Last reset from PowerUp

96 FastEthernet/IEEE 802.3 interface(s)

4 Gigabit Ethernet/IEEE 802.3 interface(s)

403K bytes of non-volatile configuration memory.


Configuration register is 0x2102


4k#show module


Mod Ports Card Type Model Serial No.

----+-----+--------------------------------------+-----------------+-----------

1 2 1000BaseX (GBIC) Supervisor(active) WS-X4515 JAB0704054C

2 2 1000BaseX (GBIC) Supervisor(standby) WS-X4515 JAB07050723

4 48 10/100BaseTX (RJ45)V WS-X4148-RJ45V JAE0621004J

5 48 10/100BaseTX (RJ45)V WS-X4148-RJ45V JAB044007NK


Please rate all posts.

averheaghe Wed, 07/12/2006 - 08:25
User Badges:

The Supervisor eng is an older SupII, still running CatOS 7.3.(2)

I'm actually looking to get the version of software on the Supervisor eng and trying to find out what power supply is in it to plan for blade upgrades.

Thanks, Andy

Roberto Salazar Wed, 07/12/2006 - 08:48
User Badges:
  • Gold, 750 points or more

Okay, you just said your CatOS is 7.3(2), That is your software version.

In addition show environment power will tell you what kind of power supply you have:


Console> (enable) sh environment power


PS1-Type PS2-Type PS3-Type

----------------- ----------------- -----------------

WS-X4008 WS-X4008 none


PS1-Status PS2-Status PS3-Status PEM Installed PEM Powered

---------- ---------- ---------- ------------- -----------

ok ok none no no



Please rate all posts.

Actions

This Discussion