07-28-2006 04:48 AM - edited 03-03-2019 01:29 PM
Hi community,
Does the ip multicast boundary command work in both directions i.e in and out?
Thanks,
Mats
Solved! Go to Solution.
07-28-2006 07:07 AM
Yeah, it works in both directions. Check
Usage Guidelines
Use this command to configure an administratively scoped boundary on an interface to filter multicast group addresses in the range defined by the access-list argument. A standard access list defines the range of addresses affected. When this command is configured, no multicast data packets are allowed to flow across the boundary from either direction.
07-28-2006 07:07 AM
Yeah, it works in both directions. Check
Usage Guidelines
Use this command to configure an administratively scoped boundary on an interface to filter multicast group addresses in the range defined by the access-list argument. A standard access list defines the range of addresses affected. When this command is configured, no multicast data packets are allowed to flow across the boundary from either direction.
07-29-2006 06:38 AM
Thanks for the clarification.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: